Building movement and cracking

The cracks are the things of the house and the buildingรับสร้างบ้านราชบุรี. Because almost no houses are left without cracks. But some cracks are cracks that may be dangerous to us, such as A crack in the middle of the beam is a crack formed by concrete. Not plaster with vertical cracks. perpendicular to the horizontal beam at the center of the beam If the crack is a bit more, it will be seen as a crack at the bottom of the beam (ah) wider than the upper part of the beam. This kind of symptom indicates that the beam of the house รับสร้างบ้านโคราช has to bear more weight than usual. Therefore, it bends down to form an arc. When it bends, it will cause the concrete to split into cracks.

As you can see, what should be done first is Go upstairs to see In the area of ​​the beam we put something heavy. overlap it or not If you put something heavy I had to quickly remove that weight. and the beam will have a chance to return to its original position But if you explore and have no weight placed as a special case at all It indicates that the beam may not be able to support the weight of its own structural system. The problem may not be in our use. It must be examined by a knowledgeable person further.

This structural deformation problem It is the initial cause of the building disaster. Please do not restrain yourself. Always consult with a structural engineer. for the benefit of our own happiness

The cracks at the head of the pillar, should I hurry to get life insurance?

The cracks that are considered one of the most dangerous in our homes are An oblique crack at the head of the pillar, where the beams are attached to the pillars on both sides. It may be an oblique mark at the end of the beam or at the head of the pillar at all. This symptom shows that The beam was unable to bear the weight. shear and the beam may come off the column’s head when the beam is released from the column’s head; the Structural system was a disaster. May cause the entire building to collapse flat and lie on the ground. and it might happen quickly. until we ran away from home

If we see symptoms like this There are two options for us. The first choice is Rushed to contact life insurance. so that the next generation does not have to suffer from property or the second option is to Hurry up to consult a structural engineer to check the symptoms and give advice. and corrected in a timely manner

Some cracks, pillars between the wall and pillars how dangerous

Some houses have cracks or small cracks. Occurred at the junction of the wall and the pillar as a small mark attached to the pillar Sometimes there might be a light coming in. Some places will be leaks when it rains. If this crack does not spread to the wall or spread to the pillars of the structure and the walls were not tilted or swayed. There is no danger to worry much.

The reason for this is because the wall may not be plugged into the “tentacles”, which is small rebar about 1 foot long on one side that is inserted into the structural pole. The other side is embedded in the masonry wall. Between the bricks, there is a distance of about 1 foot. This steel mustache will serve to hold the wall and the column together. It helps to prevent the wall from wobbling or twisting. This will prevent cracking into vertical grooves. between the wall and the structure column

Fixing is similar to fixing cracks that occur under the beams. Solve the root cause of good work control Do not extract the cracks wide open and put cement sand in them. (because the same cracking will occur) and the easiest way is to Take the flexible crack binder injected into the crack. which when done correctly according to the process, will last for about 2 – 4 years and must be checked and may use the same methods to fill the cracks further.

What does the longitudinal crack near the bottom of the beam mean?

Longitudinal cracks in reinforced concrete beams The bottom area near the bottom of the beam is a continuous line, meaning that the steel in the beam that is reinforced as the bottom steel of the beam is likely to rust. or the thickness of the concrete covered with steel in that area The thickness is not as specified. (Usually caused by pouring concrete and not checking the rebar secondary mortar, which is not level), moisture may also pass through the rebar. and causing the bottom rebar to have a problem

Cracks because the bottom iron has this problem. This will make the beam withstand less tensile strength. Don’t try to fix it yourself if it’s not urgent. It’s safer to consult a structural engineer first. If it’s just a little The engineer may have just had to extract the concrete. Quality rebar adjustment. Then cast a new substance to cover the steel, if the symptoms are heavy, it may be demolished. And rebuilding that beam, it has a longitudinal crack in the reinforced concrete beam. The bottom area near the bottom of the beam is a continuous line, meaning that the steel in the beam that is reinforced as the bottom steel of the beam is likely to rust. or the thickness of the concrete covered with steel in that area The thickness is not as specified. (Usually caused by pouring concrete and not checking the rebar secondary mortar, which is not level), moisture may also pass through the rebar. and causing the bottom rebar to have a problem

Cracks because the bottom iron has this problem. This will make the beam to withstand less tensile strength. Don’t try to fix it yourself if it’s not urgent. It’s safer to consult a structural engineer first. If it’s just a little The engineer may have just had to extract the concrete. Quality rebar adjustment. Then cast a new substance to cover the steel, if the symptoms are heavy, it may be demolished. and make a new beam

%d bloggers like this: